that looks better ;) I will start playing with next week :)

Hi, Did an update and then tried with a fresh installation, but the camera is not showing up on the setup page. tested the camera with raspistill and it works.

@Michael Ng that would be great. Thanks

Both logs are empty. I noticed that the docker service is not starting.

That solution solved it. both speaker and microphone dropdowns are filled in. Camera not since no CEP supported camera available.

Linux raspberrypi 5.10.63-v7l+ #1457 SMP Tue Sep 28 11:26:14 BST 2021 armv7l GNU/Linux installed on SD card using 'Raspberry Image Manager" -> Raspberry OS Lite 32bit

@Michael Ng

waited for 40min, no difference

@Michael Ng

@Michael Ng Have installed CAIT on that Pi for the moment but all three dropboxes were empty, nothing to select for microphone. I'll reinstall cep on another PI for a screenshot.

@Michael Ng No, says "connection refused" as well.

I know, but the OAK-D is more expensive... for just a bit more, I will have a 3-pack of OAK-D lites ;)

null Discard all samples (playback) or generate zero samples (capture) jack JACK Audio Connection Kit pulse PulseAudio Sound Server default playback ac108 usbstream:CARD=Headphones bcm2835 Headphones USB Stream Output sysdefault:CARD=seeed4micvoicec seeed-4mic-voicecard, bcm2835-i2s-ac10x-codec0 ac10x-codec0-0 Default Audio Device dmix:CARD=seeed4micvoicec,DEV=0 seeed-4mic-voicecard, bcm2835-i2s-ac10x-codec0 ac10x-codec0-0 Direct sample mixing device dsnoop:CARD=seeed4micvoicec,DEV=0 seeed-4mic-voicecard, bcm2835-i2s-ac10x-codec0 ac10x-codec0-0 Direct sample snooping device hw:CARD=seeed4micvoicec,DEV=0 seeed-4mic-voicecard, bcm2835-i2s-ac10x-codec0 ac10x-codec0-0 Direct hardware device without any conversions plughw:CARD=seeed4micvoicec,DEV=0 seeed-4mic-voicecard, bcm2835-i2s-ac10x-codec0 ac10x-codec0-0 Hardware device with all software conversions usbstream:CARD=seeed4micvoicec seeed-4mic-voicecard USB Stream Output looks fine to me

@Michael Ng Installed CAIT as suggested. But the the http:///setup link doesn't work. "ping " works fine, so hostname is not the issue and yes, I changed the hostname to the name I wanted (as configured in local DNS).

@Michael Ng I am on the OAK-D Lite kickstarter, so I will have to wait until they deliver then.

Yes, that solves the grey screen. Shouldn't the 4-mic respeaker be detected on that setup screen? Driver was installed as provided on the CEP install page.

Managed to get it installed. But the http:///setup just gives me a gray screen. So, not sure what i couldn't do there. Going to /programming, is showing me the interface. Rpi has the HQ camera connected and the respeaker 4-mic HAT. I didn't find a 'Initialize Vision' block, just "Initialize OAK-D vision" which will not work yet since the OAK-D Lite is still on Kickstarter... Anyway to use the HQ camera?

Installed a fresh Raspberry OS Lite on 64GB SD on RPI4b-8GB. after the "bash setup.sh", the pi restarted but after the reboot, the webservice is not responding...